CrossFit

CrossFit Progress: Overhead Squat PR!

Nick PalomoLeave a comment

After weeks of heavy overhead squats, it was time to test my max. I wasn’t feeling confident going into today. I have been trying to get over a cold since Sunday but after last weeks 3rm PR, I was going to try my best. My target for today was 205 lb. and I was able to successfully finish the lift. I attempted 215 lb. but I wasn’t able to get the weight overhead. If I was able to get another attempt I would have done a split jerk instead of a push press. I am very happy with my result and I am looking forward to the next strength cycle. PR video below.

Lift Heavy and Level Up!

My Week as RX (Probably Scaled): August 17 – August 23

Nick PalomoLeave a comment

Monday

Started out with some mountain climbers, wall balls and lateral lunges to warm up our legs and hips before we started our strength portion for today.

Front Squat – 5 at 60%, 5 at 70%, 3 at 80%, 3 at 85%, 3 at 90% (1RM is ≈ 295 lb.)

I haven’t been doing front squats regularly and this was a challenge at 85% and 90%. I focused on getting my hips back and leading with my elbows. I hope more front squats are programmed down the line.

WOD (Partner) – AMRAP 25 minutes, 500m row, 40 Deadlifts, 30 HSPU, 20 Hang Power Cleans, 10 Muscle Ups. Every five minutes, 20 burpess

This was my dad’s first day after the on ramp and I decided to do this partner WOD with him.We used the same weights instead of getting two barbells out and I also scaled the muscle ups. I wanted to keep a pace that my dad could keep up with. He did great, scaling the movements so that he was constantly moving. It was a great experience and I’m happy that he’s getting some exercise.

Plank Holds – 3 rounds at 60 seconds each.

Used a 25 lb. plate and had a 30 second rest in between rounds.

Tuesday

Bench Press – 5 at 60%, 5 at 70%, 3 at 80%, 3 at 85%, 3 at 90% (1RM is 240 lb.)
Haven’t done heavy bench presses in a while but these were not too bad. Went a bit lighter than the posted percentages but I was more focused on form than the weight.
WOD – AMRAP 7 minutes – 1 Front Squat at 135 lb., 2 Ring Dips. Add 1 rep to front squat and 2 reps to ring dips each round. 
This WOD was difficult but I manged to make it up to the six front squat round. I decided to use a 135 lb. bar since it was close to my front squat 1RM and I would be able to speed through the front squats. I knew coming into this WOD that the ring dips were going to slow me down a lot. I’m not great with body weight movements and the bench press was taxing on the triceps. Also, my ring dip kip is not great which slowed me down. I need to work on more gymnastics.
Burpee onto Plate – For Time – 50 reps
My arms and chest were still recovering from previous workouts, making me hate the burpees that much more. Surprisingly I finished this in 4:53 which I’m happy with. I was shooting for sub four minutes but I have a goal to aim for next time. 

Wednesday

Overhead Squat –  5 at 60%, 5 at 70%, 3 at 80%, 3 at 85%, 3 at 90% (1RM is ≈ 200 lb.)

I hit a PR during this workout. My previous  3RM was 175 lb. and I managed to lift 180 lb. I can tell my form is improving, at heavier weights I have to fight for position but it’s becoming easier. Hopefully I can set a new 1RM next week.

WOD – 4 x RFT 400m Run, 10 Power Snatch (75 lb.), 15 Box Jumps. Rest for 2 minutes after each round.

This WOD was fun and challenging. I decided to use a 75 lb. bar since I wanted to get through the snatches and box jumps as fast as possible. Managed to be consistent with my time and finished all rounds under 4:20.

Friday

Thruster 1RM 
This was my first max thruster attempt. I was able to lift 205 lb. but it was difficult. I’m not sure if I could have went heavier.
WOD – 4x AMRAP 3 minutes – 6 Mountain Climbers, 9 Sit Ups,  12 Wall Balls (20 lb.). Rest 1 minute between each AMRAP.

My main goal was being consistent and I managed to finish at least two rounds every set. The wall balls were what slowed me down the most.

Lift Heavy and Level Up!



My Week as RX (Probably Scaled): August 10 – August 16

Nick PalomoLeave a comment

I wanted to keep track of my workouts and decided to add them to the blog. Now I have a written record of my training that I can reference.

Tuesday

Started off Tuesday with lat and shoulder warm up and then moved on to the skill portion of the day. The skill portion was a chest to bar complex and toes to bar.

6×2 – 1 strict chest to bar, 2 kipping chest to bar, 3 toes to bar (Unbroken)

I wasn’t able to complete this skill portion because my grip started to fail, my hands were starting to feel a bit raw and I wanted to save my hands for the WOD.

WOD – 3 Toes to Bar, 3 KB SDHP (Reps increase by 3 after each round)

I was a bit conservative during the WOD since I didn’t want to tear but managed to make it to the fifth round before time ran out. After the WOD, I spent about ten minutes on mobility.

Wednesday

Did a short five minute warm up of Double unders and overhead squats before we went into the strength portion.

6×3 – Overhead Squats at 80% of 1RM (165 lb.)

The overhead squat is not one of my strong lifts. I need to work on keeping my hips back and not bending at the knee first. I’m slowly improving and the lifts are becoming easier.

WOD – 400m, 50 burpees, 800m, 50 burpees, 400m

This WOD was rough. Two movements that I do not like, running and burpees. I managed to finish in 24 minutes but it was a grind. Finished the class with some mobility.

Thursday

Thursday was another skill day focusing on core strength and hand stand push ups. The warm up was a 500 m row and then four, fifteen second holds. The holds were a head stand, a hand stand, a L-sit from a bar and a ring support. The skill portion was broken up into two complexes.

6×2 – 1 Ring Push up, 2 ring plank

The ring planks are very similar to an “ab-wheel” plank.

6×1 – 2 Strict Deficit HSPU, 6 Kipping HSPU, Max Effort Kipping HSPU

I used two 45 plates for my deficit and managed to finish four of the six sets. I ran out of time since I took a longer rest period in between sets.

WOD: 4 RFT: 25 Bench Press at 75% body weight, 500m row, 4 minutes of rest between rounds.

Wasn’t able to do this WOD Rx since it would take forever for me to complete. 75% of my body weight would be 150 lb. I decided to scale down to 50% of my body weight. I manged to finish the WOD in 24 minutes. Finished the class with some mobility.

Friday

Started the class with 10 minutes of mobility and then started the strength portion.

6×5 – Back Squat at 75% of 1RM

Did the squats at 265 lb. and they felt great. I struggled a bit in the fifth set but other than that, manged to get through it without any issues. I realized it’s easier to get your hips back during back squats than overhead squats.

WOD –  Reverse Tabata: Row (Cal), Ski Erg (Cal), Box Jumps and Air Dyne.

This WOD is very deceiving. Manged to stay consistent throughout the workout and movements. Finished the class with some mobility.

Lift Heavy and Level Up!

CrossFit Progress: Overhead Squat 3 Rep Max PR!

Nick PalomoLeave a comment

The last time I tested my three rep max for the overhead squat was five months ago in February. Since then, I worked on a lot of shoulder strength. From handstand push ups to strict press, the programming focused on the shoulders and it showed. I was able to add 20 lb to my overhead squat three rep max bringing my new three rep max to 175 lb. I didn’t have much time but I could have added another five to ten lb to that number. I missed my attempt at 195 lb, I was either too fatigued from the previous lifts or it was too heavy. I want to work on more accessory lifts, especially the overhead squat.

Lift Heavy and Level Up!

CrossFit Progress: PRs!

Nick PalomoLeave a comment

This week is our “max out” week for CrossFit Gof Metgot. So far we had a max day for bench press, deadlifts, hand stand push ups and strict pull ups.

PRs from Monday and Tuesday:

  • Handstand Push Ups – 13, +5 reps 
  • Bench Press – 240 lb, +15 lb 
  • Strict Pull Ups – 10, +4 reps 
  • Fran – 7:07, -4:53 from previous time
I’m happy with all the numbers I put up and the progress I have made. I’m especially happy with my Fran time. I didn’t finish my last Fran attempt under the 12 minute time cap. Also, I didn’t finish all the thrusters in the last set. This time I manged to almost knock off five minutes from my last attempt and finish. Fran is one of those iconic CrossFit workouts and hopefully I make it under seven minutes next attempt. More lifts are coming, I recently hit a new PR on my clean and jerk but I’ll write about that next time. I want to max out my deadlift this week, wish me luck. 
Lift Heavy and Level Up!

CrossFit Progress: Snatches, Snatches, Snatches.

Nick PalomoLeave a comment

My snatches need a lot of work. Last Friday I tried to hit a PR on my snatch. I attempted to lift 160 lb. which is 5 lb. over my current max. I failed all three attempts, but I almost made my last lift. I think with some more strength training and more practice I’ll be able ready. I need to work on some drills for speed  under the bar. I’ll talk to my coach and see if I can get some snatch balance work in. In other news I dropped 10 lb. and I’m finally down to 200 lb. Still have 30 – 40 lb. to go.

Lift Heavy and Level Up!

CrossFit Progress: New Clean and Jerk PR!

Nick PalomoLeave a comment

I finally hit a PR on my clean and jerk. My previous PR was 205 lb. and today I lifted 215 lb. I learned that your mental state plays a big role in heavy lifts. I made two attempts at 205 and missed one of them. The difference between the two lifts were my mental state. I wasn’t 100% during my missed lift; I wasn’t focused. After reevaluating and some notes from my coaches I made the lift. I felt really good after and decided to try and PR.

Thankfully, it only took one attempt. My coaches were trying to get me to attempt 225 lb but I decided against it. I only had a few minutes left and I didn’t want to rush it. The next time a max clean and jerk comes up, I’ll definitely attempt 225 lb. I wanted to post a video but it didn’t come out well, next time.

Lift Heavy and Level Up!

Review: Nike MetCon 1

Nick Palomo2 Comments

When you think Nike, you think sport and with CrossFit becoming more mainstream, it would make sense for Nike to enter the market. I think it is safe to say the Nike MetCon 1 is one of the most sought after CrossFit shoes. The marketing hype combined with the limited number of shoes available at launch made them that much more desirable. I felt like I was trying to buy a pair of new Kobe’s or Jordans rather than a pair of CrossFit shoes. If you didn’t get a pair within the first hour of launch, you were out of luck. Thankfully, my fiance manged to order a pair online and they have been my go to CrossFit shoe for a few weeks.

Looks, Fit and Construction

The Anthracite/Black/Cool Grey colorway are my favorite colors from the launch. The shoe has a unique color pattern with the shoe divided up in four sections. The divisions are more noticeable with the other colorways. Ordering shoes online is risky especially when it comes to new shoe models. Thankfully the shoe felt true to size. The shoe fits snug but after you break them in, they feel great. The toe box has enough room to spread your toes which is great for lifts. The shoe is also wider which allows for a stable base.

Since this is a Nike shoe, you’re bound to see some of their tech. The shoe features Flywire, which helps to lock your feet down and gives support to certain areas of the foot.  A Hyperfuse upper and a rubber midsole is more for rope climbs. The newer Flyknit material would probably rip after a few rope climbs making the Hyperfuse upper ideal. After a few weeks of use, the shoes almost look brand new. The excellent shoe quality is what I expect from Nike.

Performance

My first workout in the Metcon 1 was great for a performance test. It was a FGB style workout with wall balls, thrusters, rowing, double unders, burpees and box jumps. Throughout the workout the shoes held up great. I felt stable during all movements. I had no problem jumping during box jumps, it also had a slight spring. The shoes perform well during heavy oly lifts and heavy squats. I felt stable in the bottom position of the lift and the shoe didn’t give as much as I was expecting. The insole is a little thick but the heel area felt solid during lifts. The shoes have great grip and the sticky rubber soles are indeed sticky. I didn’t feel my feet slide around during split jerks or lunges. The midsole grip felt great during rope climbs and the upper held up. Checking the shoes after, it didn’t have any scratches or tears.

During a run however, I noticed most of the flaws of this shoe. My feet felt heavier during runs and the rigidness of the sole is not comfortable. If I know running will be programmed for the day I will use different shoes.

Final Thoughts

The Metcon 1 is a great shoe and is now my favorite shoe to use during CrossFit. It covers almost all workouts except for running. They are holding up well and if I wipe them down with a damp cloth, they will look good as new. I’ve read that the newer versions of the Metcon 1 have some changes to material and construction. I plan to get another pair in another color, and I will update this post if I think the changes will make a difference. My next shoe review will be on the Fastlift 335. Hopefully it will be done in a few weeks. If you have any questions or comments, enter them below.

Lift Heavy and Level Up!